Preparing a Gameboy DMG Shell
Remove all posts marked in red completely.
To make room for the Raspberry Pi Zero / Zero 2, remove these areas marked in red. Stop before the posts closest to the cartridge opening.
On some shells, there is a small raised piece of plastic, remove this too...
To make room for the Raspberry Pi Zero / Zero 2, remove these areas marked in red. Stop before the posts closest to the cartridge opening.
On some shells, there is a small raised piece of plastic, remove this too...
Related Articles
Preparing your SD Card
How to download and flash an SD card for your device To prepare an SD card to use in your device you will need An SD Card (Minimum 8GB) A copy of either Balena Etcher, Win32DiskImager or Raspberry Pi Imager Download the required image from the Zega ...Zega Mame Boy Pre-install Checks
Installation of the Zega Mame Boy+ requires soldering to complete the setup. Only attempt if you are confident in your soldering ability. By attempting to complete the setup of the Zega Mame Boy+ you are confirming that you accept responsibility for ...