Safe Shutdown GPIO Module
The Raspberry Pi Safe Shutdown Module is designed to be plugged into the 40 Pin header of your Raspberry PI. An 8 pin header block is provided that needs soldering to the Safe Shutdown board. Alternatively you can wire the board manually if you need to mount the board in an alternative position for your project.
Improper use of the Safe shutdown board can result in the death of your Raspberry Pi. Please pay careful attention to how you install the board.
Software setup
1. Edit the boot/config.txt file and add the following:
#Shutdown Button
dtoverlay=gpio-shutdown,gpiopin=3
#Shutdown Trigger
dtoverlay=gpio-powero,gpiopin=4
2. Save the changes and reboot your Raspberry Pi for the changes to take effect.
sudo reboot
Where to buy
The GPIO safe shutdown module is available through the store
Related Articles
Manually adding the Safe Shutdown Script
This process works for all devices. All pre-made images available to download are already configured with this script 1. Login to your Raspberry Pi via Putty 2. Edit the config.txt file sudo nano /boot/config.txt 3. Add the following lines to the end ...
Desktop Arcade - What is it?
A custom miniature arcade kit. Runs on a Raspberry Pi and allows you to play thousands of retro games using Retropie. Uses rechargeable lithium batteries which can be recharged via USB-C or runs on mains power. Includes safe shut-down and power-off ...
Zega Mame Boy Advance Solder Guide
Top Side PWR: LED (RED) ACT: LED (GREEN) Bottom Side LED1 - LED (RED) LED2, LED3, LED4: LED (GREEN) SW1, SW2: Trigger R1: 1MΩ R2, R6, R7: 2KΩ R3, R4: 2Ω R5: 10Ω C1, C2, C7, C8, C9, C10: 10uF C3: 100nF C4, C5, C6: 22uF Q1: SS (Safe Shutdown) IC Q2: ...
Zega Mame Gear Pre-install Checks
Power Board Connect the power board to a USB-C power source Ensure the battery level LEDs illuminate Mainboard Disconnect the USB-C power supply Connect the Power Board to the Mainboard using the supplied 4 pin connector Toggle the power switch ...
Zega Mame Boy Pre-install Checks
Installation of the Zega Mame Boy+ requires soldering to complete the setup. Only attempt if you are confident in your soldering ability. By attempting to complete the setup of the Zega Mame Boy+ you are confirming that you accept responsibility for ...